【Bend】 to 【center wire】 of 【handmade lure】


【Bend】 to 【center wire】 of 【handmade lure】

Hello, I am Sekino Urusi by

“rein to pencil”


I run lucquer workshop

“Sekino Urusi” 



  Well, this time

“The method of forming the wire for the center axis of a handmade lure”

What do you use for the center axis?

How do you mold it?

I will explain the wire of the center shaft.

Be reading this article

You can learn

about the method of forming the core wire.

Try it over and over again.

There is always a failure in forming the wile.

So it’s important to try many times to increase the success rate.


Let’s take a look now.

First, prepare a wire.

The best wire is stainless steel, 0.9mm

Measure the required langth and make it with a marker.

Cut as much as you need.

Pinch with a pointed pliers.

Press and bend like this.

Mold with the other pliers.

Make the points to be bent with the marker.

First, bend the first point at a right angle.

The second point is molding.

And next is a right angle.

Finally, it is molded again.

Like this.

Of course…

At first it does not work at all…

You also have to find the bending point by groping.

The most


try it over and over again.

I hope this article will help your process.

If you have any questions about the article or if you have any concerns about lacquer, Please contact us.


#4c kanseihome coco2 216-4
azaminatogawa yaesetyou simajirigun okinawa
Phone 070-3800-3226

Inquiry form

About the author

rein administrator

Leave a Reply